Alcatel 6648 User's Guide download pdf (Page 33)

OmniSwitch 6600 Series Chassis and Hardware Components Mounting the Switch

OmniSwitch 6600 Series Hardware Users Guide April 2004 page 2-13

Mounting the Switch

Note. If you are relocating the switch, be sure to power it down and remove all network, stacking, and

power cables before moving.

Airflow Considerations

Be sure that your switch is placed in a well-ventilated, static-free environment. Always allow adequate

clearance at the front, rear, and sides of the switch.

The following diagram shows recommended minimum clearances for adequate chassis airflow and access

to components at the rear of the chassis—e.g., back up power supply and power switch(es).

OmniSwitch 6600 Series Chassis Top View

Note. Never obstruct the air intake vents located at the sides of the chassis. Obstructing these vents can

cause switch failure. Clearance is not required at the top and bottom of the chassis. For detailed chassis

airflow diagrams, refer to “Chassis Airflow” on page 2-47.

}

Rear Recommended 5 inches

minimum at rear of chassis for

access to power switch(es) and

power cord(s).

Sides 2 inches minimum at left

and right sides for adequate air-

flow. For detailed information on

chassis airflow, refer to page 2-47.

Front Recommended 6 inches

minimum at front of chassis for

access to LEDs and network

cables.

}

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 113 114

No comments

Alcatel 6648 User's Guide Page 33