40
Upgrading from SD card
Upgrading from SD card may be suitable if you have many phones to upgrade. The
phones do not have to be connected to the network.
Download the latest rmware as above and save it on a SD card.
Put the SD card in the phone you want to upgrade.
Disconnect the power supply cable. Note that this is the same as the network cable
if the phone uses Power over Ethernet.
Press and hold the MENU button while you connect the cable again (i.e. starts the
OmniTouch 4135 IP). Hold the button pressed until the SYSTEM RECOVERY menu
is shown on the display.
You can press any other button than 1, 2, or 3 to start the phone without any
change.
Press 2 to select SD-card upgrade.
The OmniTouch 4135 IP is upgraded with the rmware le on the SD card and starts when the
upgrade is done.
After upgrading
If DHCP is used in the network, the IP address may have been changed. If the web
browser loses contact with OmniTouch 4135 IP, check the IP address on the conference
phone (see “USING THE WEB INTERFACE” on page 6).
USING A CONFIGURATION FILE
It is possible to save a conguration xml le to be used as:
• Backup (i.e. if the system has been reset to factory default)
• Conguration interface (there are some settings that are not congurable via the
web interface)
• Management tool (export, edit and import settings to a set of phones instead of
doing the settings on each phone)
• Use with a Provisioning server, see page 47.
The structure of the xml le is as follows:
MANAGEMENT – UPGRADE AND CONFIGURATION
Comments to this Manuals