Alcatel IP Touch 4018 User Manual download pdf (Page 15)

Page 15

2/5 network setup Phase 2 is running: the set is looking for IP

addresses

3/5 config download Phase 3 is running: the set is trying to get a

lanpbx file

4/5 binary download Phase 4 is running: the set is downloading a new

binary

5/5 connecting Phase 5 is running: the set is trying to set up the

signaling link with the system

802.1x Auth Failed 802.1x authentication has failed: RADIUS server

is unreachable, access is refused to the terminal

on the RADIUS server or the terminal has an

incorrect identity (bad login and/or password).

802.1x Auth Success 802.1x authentication process is complete. The

RADIUS server grants access to the terminal, the

authenticator opens its port.

3.3. Ethernet Link

By default, IP Touch sets are configured to perform auto-negotiation on both ports (LAN and PC).

Provided that the PC and the LAN switch are also configured to perform auto-negotiation, this is

the best configuration for QoS improvement.

However, depending on the network configuration, it may not always be possible to leave the

terminal in auto-negotiation: link speed and duplex of both ports can be forced to determined

values using the supervisor menu:

– Plug in the set, as described: module IP Touch 4008 EE/4018 EE Phone - Commissioning §

Commissioning the 4008 EE or 4018 EE IP Touch Set.

– Once the set displays initialization, press i, then # or enter the admin settings during phone

idle status.

– Use the navigation key to select Ethernet Links

– Modify data as requested

A configuration mismatch between the terminal and PC/LAN switch can lead to nasty effects on

the voice quality:

– No link (or speed mismatch): 8, 9, 11 and 12

– Packet loss (or duplex mismatch): 2, 4, 7 and 14

1 2 ... 10 11 12 13 14 15 16 17

No comments

Alcatel IP Touch 4018 User Manual Page 15